The Agilent/HP E5346A Mictor probe provides a convenient and reliable connection to your target through a Mictor connector designed into your target. Route your signals of interest to the location containing the Mictor connector and when you are ready to measure these signals simply plug-in the Mictor probe. These probes can be used with a support shroud in environments where accidental unplugging of the probe is a concern. This probe can be used with any Agilent/HP logic analyzer with a 40-pin cable connector.
The E5346A probe includes the required isolation networks for the logic analyzer right at the probe tip, close to the target. The E5346A is designed to acquire signals with peak-to-peak amplitude as low as 500 mV.
Key specifications:
• 34 channels: 32 single-ended data, 2 single
ended clock
• 3.0 pF equivalent load capacitance
• Equivalent to the logic analyzer data rate the
probe is attached to
• Measure signals with as little as 500 mV p-p
signal amplitude
• Provides convenient, reliable connection to
target through Mictor connector
• Mictor connector is easy to incorporate into
your design, Agilent number 1252-7431 or AMP
number 2-767004-2
• Can be used with support shroud
• Compatible with logic analyzers with 40-pin cable connectors
• Support shrouds available for board thickness
to 0.12 inches
• 38-pin Mictor footprint
- 
| 
|