The E5383A flying lead set is the tool to use when probing points are dispersed on your target or a probing point was not designed in. This probe can be connected to designed-in connectors or used with the included IC test clip to attach to components and other board features. This probe can be used with any Agilent/HP logic analyzer with a 40-pin cable connector.
Key specifications:
• 17 channels: 16 single-ended data, 1 single
ended clock
• 1.5 pF equivalent load capacitance
• Equivalent to the logic analyzer data rate the
probe is attached to
• Measure signals with as little as 600 mV p-p
signal amplitude
• Acquire signals from randomly located points
in your target
• Can be connected to designed-in connectors
or used with the included IC test clip
• For logic analyzers with 40-pin cable
connectors
• Connects to 0.63mm square pins or 0.66
0.84mm diameter round pins
- 
| 
|